Motorcycle Mounts|Whip-It Flags

Motorcycle Seat/Fender Mount

cm — Mon, 06 Jun 2016 18:12:45 +0000

Fits same as the smaller seat mount, but may also be mounted to the rear fender (will require drilling a small hole in the rear fender).

Includes mounting hardware.

Motorcycle Seat Mount

cm — Mon, 06 Jun 2016 17:54:50 +0000

Fits most motorcycles that use a common seat / fender / side-panel attaching point.

Includes mounting hardware.

The Clamp-On Holder

Taylor — Sat, 14 May 2016 00:33:05 +0000

The Clamp-On Holder is designed to be fast and easy to install. Place the holder over your rear axle nut, tightening the Allen screw (wrench provided) insert your flag and you’re ready to go.

Clamps over the exterior of the swing arm axle nut.
Comes with Allen wrench and new cotter pin.
The 12 point star allows rider to angle the safety flag where desired.
Ejection slot for easy removal of broken flags.
Allows riders to reuse their flag multiple times before replacing.
Thumb screw enables rider to remove flag when desired.

Sizes Available: 32mm, 27mm, 24mm, 19mm, 17mm.

Note: When ordering the Clamp-On holder you will need to know your rear axle nut size. If you do not know the size of the axle nut. You may use a metric socket or wrench to find the correct size.

The Bolt-On Holder

Taylor — Sat, 14 May 2016 00:31:47 +0000

The Bolt-On Holder is designed to be universal for most motorcycles. To install remove the rear axle nut, place holder on the axle, reinstall the axle nut and tighten, insert flag and you’re ready to go.

Bolts under the rear axle nut.
Quick and easy to install.
No longer do you need to buy two pieces to mount your flag.
Comes with an ejection slot to aid in the removal of broken flags.
Anodized for appearance and durability.
Thumb screw enables the rider to remove or install a safety flag with ease.
Holds 1/4 inch diameter poles only.
Available in Right side or Left side mounting (be sure to purchase the correct one for your needs).
Comes with a new cotter pin.

sizes: 2 1/2 x 1 1/2 inches.
Note: Available in Right side or Left side mounting (be sure to purchase the correct one for your needs). Comes with a new cotter pin.

Angle Bracket

Taylor — Sat, 14 May 2016 00:31:09 +0000

The Angle Bracket is designed to be universal for most motorcycles, boats, trucks, forklifts and construction equipment. For motorcycles, the Angle Bracket clamps under the rear axle nut and requires that you purchase flags with bolts on the bottom. We recommend that you use the Original ATV Flag Holder with the Angle Bracket. This allows the flag to sit 3 inches higher off of the swing arm and may help prevent needless breaks.

Clamps under the rear axle nut.
Works with bolts 3/8″ to 1″.
Used for multiple applications.